Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA1996TERCEL DX, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM TESTS W/CODES
1996 Toyota Tercel DX, 4D Sedan, Automatic
Engine Control System Tests W/Codes
1996 Toyota Tercel DX, 4D Sedan, AutomaticSECTION Engine Control System Tests W/Codes
- Introduction
- Self-Diagnostic System
- Scan Tester Problems
- Circuit Tests
- Notes
- DTC P0105 - Manifold Absolute Pressure/Barometric Pressure (Map) Sensor Circuit
- DTC P0106 - Manifold Absolute Pressure/Barometric Pressure (Map) Sensor Circuit
- DTC P0110 - Intake Air Temperature (IAT) Sensor Circuit
- DTC P0115 - Engine Coolant Temperature (ECT) Sensor Circuit
- DTC P0116 - Engine Coolant Temperature (ECT) Sensor Circuit Range/Performance Problem
- DTC P0120 - Throttle Position (TP) Sensor Circuit Malfunction
- DTC P0121 - Throttle Position (TP) Sensor Circuit Range/Performance Problem
- DTC P0125 - Insufficient Coolant Temperature For Closed Loop Fuel Control
- DTC P0130 - Oxygen Sensor Circuit (Sensor No. 1)
- DTC P0133 - Oxygen Sensor Circuit (Sensor No. 1) Slow Response
- DTC P0135 - Heated Oxygen Sensor Circuit (Sensor No. 1), DTC P0141 - Heated Oxygen Sensor Circuit (Sensor No. 2)
- DTC P0136 - Oxygen Sensor Circuit (Sensor No. 2)
- DTC P0141 - Heated Oxygen Sensor Circuit (Sensor No. 2)
- DTC P0171 - System Too Lean (Fuel Trim), DTC P0172 - System Too Rich (Fuel Trim)
- DTC P0300 - Random/Multiple Misfire Detected
- DTCS P0301-P0304 - Cylinders No. 1-4 Misfire Detected
- DTC P0325 - Knock Sensor Circuit
- DTC P0335 Or P1335 - Crankshaft Position (CKP) Sensor Circuit
- DTC P0340 - Camshaft Position (CMP) Sensor Circuit
- DTC P0401 - Insufficient Exhaust Gas RECIRCULATION (EGR) Flow Detected
- DTC P0402 - Excessive Exhaust Gas RECIRCULATION (EGR) Flow Detected
- DTC P0420 - Catalyst System Efficiency Below Threshold
- DTC P0500 - Vehicle Speed Sensor Malfunction
- DTC P0505 - Idle Air Control (IAC) System Malfunction
- DTC P0510 - Closed Throttle Position (CTP) Switch Malfunction
- DTC P1300 - Igniter Circuit Malfunction
- DTC P1335 - Crankshaft Position (CKP) Sensor Circuit
- DTC P1500 - Starter Signal Circuit Malfunction
- DTC P1600 - ECM Batt Malfunction
- DTC P1780 - Park/Neutral Position (PNP) Switch
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.