SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA1996T100 SR5, 4WD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM TESTS W/CODES - 3.4LSELF-DIAGNOSTIC SYSTEMRETRIEVING DIAGNOSTIC TROUBLE CODESNORMAL MODE CODE RETRIEVAL
1996 Toyota T100 SR5, 4WD, Standard

NORMAL Mode Code Retrieval

1996 Toyota T100 SR5, 4WD, StandardSECTION NORMAL Mode Code Retrieval
  1. Connect scan tester to Data Link Connector No. 3 (DLC3). Turn ignition on with engine off. Turn scan tester on. Using scan tester manufacturer's instructions, check for DTCs and freeze-frame data.
  2. If scan tester displays UNABLE TO CONNECT TO VEHICLE, DLC3 must be checked. See DLC3 INSPECTION  under SCAN TESTER PROBLEMS. If scan tester does not display UNABLE TO CONNECT TO VEHICLE, go to next step.
  3. Record any DTCs and freeze-frame data displayed for system diagnosis. If driveability problem exists and no DTCs are present, go to TESTS W/O CODES article for diagnosis by symptom.
  4. If any DTCs are present, perform appropriate circuit test. See TROUBLE CODE IDENTIFICATION  table. For more information on freeze-frame data, see FREEZE-FRAME DATA  under INTRODUCTION. For information on 2-trip detection logic codes, see TWO-TRIP DETECTION LOGIC  under INTRODUCTION.
  5. After repairs for DTC have been completed, DTCs must be cleared from ECM memory. See CLEARING DIAGNOSTIC TROUBLE CODES .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.