Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
System Overview
The ECM monitors engine operation and contains a self-diagnostic system which stores Diagnostic Trouble Codes (DTCs) and complies to On-Board Diagnostics Generation II (OBD-II) standards.
Self-diagnostic system is used to provide vehicle with an on-board diagnostic system which is capable of continuously monitoring the efficiency of emission control system, and to improve diagnosis and repair when system failures occur.
The Federal Test Procedure (FTP) sets maximum allowable emission standards. A Malfunction Indicator Light (MIL) must illuminate if a system or component either fails or deteriorates to a point where the vehicle emissions could rise above 1 1/2 times FTP standards.
If malfunction does not reoccur in 3 ignition cycles, the MIL goes off, but DTCs remain recorded in ECM memory. DTCs may only be retrieved using an On-Board Diagnostic (OBD-II) scan tester that complies with SAE standard J-1978 or Toyota scan tester connected to new standardized Data Link Connector No. 3 (DLC3). The scan tester also provides freeze-frame data and can be used to clear codes.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.