Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Back Door Key Unlock Switch Circuit
Turn ignition off and disconnect ATS ECU connector. Lock back door with key. Ensure no continuity exists between ground and ATS ECU connector terminal A1 (Blue/White wire). If continuity is present, repair short in back door key unlock switch circuit. If continuity is not present, unlock back door with key and ensure continuity is present. If continuity is not present, repair open in back door key unlock switch circuit. If continuity is present, replace ATS ECU and retest.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.