Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Standard Horn Circuit
Turn ignition off and disconnect ATS ECU connector. Ensure battery voltage exists between ground and ATS ECU connector terminal A11 (Green/Red wire). If battery voltage is not present, ensure continuity exists between standard horn relay terminals No. 1 and No. 2. If standard horn relay is okay, repair open or short in harness or connectors between standard horn relay and ATS ECU as necessary. If battery voltage is present, replace ATS ECU and retest system.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.