Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Starter Interrupt System Circuit
Turn ignition off and disconnect ATS ECU connector. Unlock either driver's or passenger's door using key. Put shift lever into Neutral or Park position (A/T) or depress clutch pedal (M/T). Turn ignition to START position. Ensure battery voltage exists between ground and ECU terminal B1 (Black/Red wire). If battery voltage is not present, repair short or open in starter relay circuit. If battery voltage is present, replace ATS ECU and retest.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.