Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA1992CAB & CHASSIS STANDARD, R150REPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - SYSTEM/COMPONENT TESTSFUEL SYSTEMFUEL CONTROLFUEL PRESSURE CONTROL SYSTEM
1992 Toyota Cab & Chassis Standard, R150
Fuel Pressure Control System
1992 Toyota Cab & Chassis Standard, R150SECTION Fuel Pressure Control System
- Ensure coolant temperature sensor operates correctly. See ENGINE SENSORS & SWITCHES.NOTE: ECU uses signal from coolant temperature sensor to control ground circuit for fuel pressure control VSV.
- VSV is supplied voltage through EFI main relay. The ECU will activate VSV for approximately 90 seconds when restarting engine at normal operating temperature. Locate and remove fuel pressure control VSV. See FUEL PRESSURE CONTROL VSV LOCATION table.NOTE: Fuel pressure control VSV may also be identified by appropriate illustration in THEORY/OPERATION article in the ENGINE PERFORMANCE Section or wire color. See appropriate wiring diagram in WIRING DIAGRAMS article in the ENGINE PERFORMANCE Section.FUEL PRESSURE CONTROL VSV LOCATION
Application Location 2.4L Near Center Of Valve Cover 3.0L Center VSV, Near Relay Box At Right Front Corner Of Engine Compartment - Use ohmmeter to check continuity between VSV electrical terminals. Ensure resistance is within specification. See FUEL PRESSURE CONTROL VSV RESISTANCE SPECIFICATIONS table.
- Check that no continuity exists between each electrical terminal and VSV body. Replace VSV if resistance is not within specification or continuity exists between electrical connector and VSV body.
- Test VSV by applying air pressure to designated area and checking air passage, and then applying battery voltage and retesting. See Fig 1 and Fig 2 . Replace VSV if defective.
FUEL PRESSURE CONTROL VSV RESISTANCE SPECIFICATIONS
| Application | Ohms |
|---|---|
| Pickup & 4Runner | 30-50 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.