Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA1988VAN BASE, VAN PASSENGERREPAIR AND DIAGNOSISENGINE PERFORMANCETUNE-UPIGNITION SYSTEMTESTINGPICK-UP COIL RESISTANCE TEST
1988 Toyota Van Base, Van Passenger
Pick-Up Coil Resistance Test
1988 Toyota Van Base, Van PassengerSECTION Pick-Up Coil Resistance Test
- On Van models, measure pick-up coil resistance at distributor connector. See Fig 1.
- If resistance is incorrect, remove ignition coil (if equipped) and replace distributor assembly.
TOYOTA PICK-UP COIL RESISTANCE
| Application | Ohms |
|---|---|
| Van | 140-180 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.