Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Throttle Positioner System: Operation
The TP system is vacuum controlled. When engine is cold, the TVSV valve is open and holds positioner in a set position. When engine is warm, throttle open, and vacuum at TP port is low, the positioner is in a set position. When throttle is released, as during deceleration, the positioner keeps it from closing completely until vacuum bleeds through VTV. The high vacuum present at the TP port will then pull the positioner back and allow throttle to close completely.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.