Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA1986PICKUP BASE, 22-RTE, R151FREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEIGNITION SYSTEM - ELECTRONICTESTINGIGNITION WIRE RESISTANCE
1986 Toyota Pickup Base, 22-RTE, R151F
Ignition Wire Resistance
1986 Toyota Pickup Base, 22-RTE, R151FSECTION Ignition Wire Resistance
- Set ohmmeter to x1000 range and attach leads to each end of high tension wire.
- Resistance should not exceed 25,000 ohms per wire. If it does, replace wires.
IGNITION WIRE RESISTANCE
| Application | Resistance (Ohms) |
|---|---|
| Ignition Coil Wire | 4030-9410 |
| No. 1 Spark Plug Wire | 5690-13,910 |
| No. 2 Spark Plug Wire | 5150-12,010 |
| No. 3 Spark Plug Wire | 4810-11,220 |
| No. 4 Spark Plug Wire | 3730-8710 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.