Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA1984CELICA SUPRA LREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSOVERHAUL - A43, A44 & A46TORQUE SPECIFICATIONS
1984 Toyota Celica Supra L
Torque Specifications
1984 Toyota Celica Supra LSECTION Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Center Support-To-Case Bolt | 19 (25) | |
| Converter-To-Drive Plate Bolt | 20 (27) | |
| Cooler Union Nut | 25 (34) | |
| Extension Housing-To-Case Bolt | 25 (34) | |
| Oil Pump-To-Case Bolt | 16 (21) | |
| Transmission Case-To-Converter Housing Bolt | ||
| 10-mm | 25 (34) | |
| 12-mm | 42 (57) | |
| Transmission Mounting Bolt | 36 (49) | |
| INCH Lbs. (N.m) | ||
| Control Shaft Lever Bolt | 61 (6.9) | |
| Governor Lock Plate Bolt | 35 (3.9) | |
| Lock Pawl Bracket Bolt | 65 (7.4) | |
| Neutral Start Switch | ||
| Adjusting Bolt | 48 (5.4) | |
| Mounting Nut | 35 (3.9) | |
| Oil Pan Bolt | 39 (4.4) | |
| Oil Pump Housing Bolt | 65 (7.4) | |
| Oil Strainer Bolt | 48 (5.4) | |
| Overdrive Solenoid Bolt | 115 (13) | |
| Throttle Cam Bolt | 65 (7.4) | |
| Upper Valve Body-To-Lower Valve Body Bolt | 48 (5.4) | |
| Valve Assembly-To-Case Bolt | 89 (10) | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.