Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA1976CELICA ST, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONCLUTCHCLUTCHESREMOVAL & INSTALLATIONPILOT BEARINGINSTALLATION
1976 Toyota Celica ST, Standard Trans
Pilot Bearing: Installation
1976 Toyota Celica ST, Standard TransSECTION Installation
Apply grease to new bearing and install into crankshaft using a suitable driver (09304-30012 for Corona and Hi-Lux models, or 09304-12011 for all other models).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.