Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTESLA2018MODEL 3 BASEREPAIR AND DIAGNOSISGENERAL INFORMATIONHOIST/JACKBODY -- MODEL 3WINDSHIELD AND BODY GLASSWINDSHIELD (HW4) - REMOVE AND REPLACEINSTALL
2018 Tesla Model 3 Base
Windshield (HW4) - Remove And Replace: Install
2018 Tesla Model 3 BaseSECTION Install
- Place the new windshield on a support stand with the windshield bracket facing up.
- Attach suction cups to the LH and RH sides of the windshield assembly.
- Clean the urethane path on the vehicle with an isopropyl alcohol (IPA) wipe. Allow the surface to dry before continuing to the next step.
- If the dash pad foam is not flush with the body, cut off the excess foam until no foam is protruding from the body of the vehicle.NOTE:
A dash pad that is not flush with the body of the vehicle may cause noise issues.
- Apply urethane primer to the windshield and vehicle body along the urethane path and in areas that were damaged during removal of the windshield assembly.CAUTION:
Be careful not to damage the headliner during application.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.