Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTESLA2018MODEL 3 BASEREPAIR AND DIAGNOSISGENERAL INFORMATIONHOIST/JACKBODY -- MODEL 3WINDSHIELD AND BODY GLASSGLASS - BACKLIGHT - REMOVE AND INSTALLINSTALL
2018 Tesla Model 3 Base
Glass - Backlight - Remove and Install: Install
2018 Tesla Model 3 BaseSECTION Install
- Use masking tape to tape the backlight glass antenna connectors to the backlight glass.
- Peel the adhesive backing off the new seal at the corner and slowly apply the adhesive backing to the adhesive path on the backlight glass.NOTE: Firmly press the seal onto the glass during installation. Ensure the adhesive is installed as close to the edge of the glass as possible.
- Peel the adhesive backing off at the end of the new trunk flip seal, and then slowly apply the seal to the old adhesive path on the backlight glass.NOTE: Start by installing the trunk flip seal where the backlight glass seal ends. Firmly press the seal onto the glass during installation. Ensure the adhesive is installed as close to the edge of the glass as possible.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.