SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTESLA2018MODEL 3 BASEREPAIR AND DIAGNOSISGENERAL INFORMATIONHOIST/JACKBODY -- MODEL 3BODY PANELSTRUNK - REMOVE AND INSTALLREMOVE
2018 Tesla Model 3 Base

Trunk - Remove and Install: Remove

2018 Tesla Model 3 BaseSECTION Remove
  1. Remove the trunk lid trim. See TRIM - LID - TRUNK (REMOVE AND REPLACE) .
  2. Disconnect the LH and RH rear fog/reverse light electrical connectors.
    G14739093Courtesy of TESLA, INC.
    G14739094Courtesy of TESLA, INC.
  3. Disconnect the rear facing camera electrical connector.
    G14739095Courtesy of TESLA, INC.
  4. Disconnect the trunk exterior release switch electrical connector.
    G14739096Courtesy of TESLA, INC.
  5. Disconnect the LH and RH license plate light electrical connectors.
    NOTE: LH shown, RH similar.
    G14739097Courtesy of TESLA, INC.
  6. Disconnect the trunk latch electrical connector.
    G14739098Courtesy of TESLA, INC.
  7. Remove and discard the bolts (x2) that attach the trunk harness ground straps to the trunk lid.
    G14739099Courtesy of TESLA, INC.
  8. Release the clips that attach the trunk harness to the trunk lid.
    G14739100Courtesy of TESLA, INC.
  9. Push the trunk harness through the trunk bulkhead and out of the trunk lid.
    G14739101Courtesy of TESLA, INC.
  10. Use a dry erase marker to mark the position of the trunk hinges on the trunk lid.
  11. Remove the bolts that attach the hinges to the trunk lid.
    NOTE: RH shown, LH similar.
    G14739102Courtesy of TESLA, INC.
  12. With an assistant, remove the lid from the vehicle, and then place it on a padded surface.
    G14739103Courtesy of TESLA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.