Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTESLA2018MODEL 3 BASEREPAIR AND DIAGNOSISGENERAL INFORMATIONHOIST/JACKBODY -- MODEL 3BODY PANELSHOOD - REMOVE AND INSTALLREMOVE
2018 Tesla Model 3 Base
Hood - Remove and Install: Remove
2018 Tesla Model 3 BaseSECTION Remove
- Remove the LH and RH hood gas struts. See GAS STRUT - HOOD - LH (REMOVE AND REPLACE) .
- Use tape to mark the mounting locations of the LH and RH hood hinges on the hood.
- With an assistant, remove the nuts that attach the hood assembly to the LH and RH hood hinges.
- With an assistant, remove the hood assembly from the vehicle and place it on a padded surface.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.