Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fender Support - Front - LH - Remove and Replace: Install
- Install the bolts (x3) that attach the LH front fender support to the vehicle.
- 10 mm socket
- Ratchet/torque wrench
Tip: Use of the following tool(s) is recommended:
35 N.m (25.8 lbs-ft)
- Install the bolt that attaches the LH front fender support to the front fender assembly.
- 10 mm socket
- Ratchet/torque wrench
Tip: Use of the following tool(s) is recommended:
9.8 N.m (7.2 lbs-ft)
- Install the bolt that attaches the LH front fender support to the front end carrier.
16 N.m (11.8 lbs-ft)
- 13 mm socket
- 3 in extension
- Ratchet/torque wrench
Tip: Use of the following tool(s) is recommended:
- Route the front harness through the LH fender support, and secure the harness to the fender support.
- Connect the LH front ride height sensor connector.
- Connect the LH front wheel speed sensor connector.
- Install the front harness clips (x3) around the LH front wheel liner area.NOTE:
American region vehicles have 2 clips.
- Install the clips (x3) that attach the front harness to the LH crush can.
- Connect the front harness from the LH acceleration sensor.
- Connect the connectors (x2) to the horn assembly.
- Connect the front harness connector for the LH front carrier harness.
- Connect the cooling fan module connector.
- Install the front harness clips (x2) around the LH headlamp area.
- Connect the LH headlamp connector.
- Install the front fascia. See Fascia - Front - Remove and Install
- Connect 12V power. See 12V/LV POWER - DISCONNECT AND CONNECT
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.