Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTESLA2018MODEL 3 BASEREPAIR AND DIAGNOSISBODY & FRAMETOWING SYSTEMSEXTERIOR FITTINGS -- MODEL 3SPOILERSPOILER - REAR - REMOVE AND INSTALLREMOVE
2018 Tesla Model 3 Base
Spoiler - Rear - Remove and Install: Remove
2018 Tesla Model 3 BaseSECTION Remove
- Use a towel and/or compressed air to clean the area surrounding the spoiler.WARNING: To avoid personal injury, eye protection must be worn while using compressed air.
- Assemble the badge removal kit by cutting an approximately 24 inch section of fishing line and connecting each end of the fishing line to a handle using a knot.
- Starting from one end of the spoiler, carefully use the badge removal kit to release the spoiler from the trunk.CAUTION: Care must be taken to avoid damage to paintwork and exterior trim.
- Use a vacuum to remove any debris or dirt from the trunk.
- Using a rubber wheel, remove any remaining adhesive from the trunk.WARNING: To avoid personal injury, eye and ear protection must be worn while performing this step.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.