Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTESLA2018MODEL 3 BASEREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMINTERIOR TRIM (MODEL 3)TRUNK TRIMTRIM - LID - POWER TRUNK - REMOVE AND REPLACEINSTALL
2018 Tesla Model 3 Base
Trim - Lid - Power Trunk - Remove and Replace: Install
2018 Tesla Model 3 BaseSECTION Install
- Install new clips onto the trim.NOTE: The trunk lid trim uses two different style clips.
- Connect the electrical harness to the power trunk switch, align the trunk lid trim tabs with the slots on the trunk lid, and then press the clips into the trunk lid.NOTE: Make sure all clips are fully seated.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.