Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTESLA2018MODEL 3 BASEREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMINTERIOR TRIM (MODEL 3)TRUNK TRIMGARNISH - TRUNK - REMOVE AND REPLACEINSTALL

2018 Tesla Model 3 Base

Garnish - Trunk - Remove and Replace: Install

2018 Tesla Model 3 BaseSECTION Install

Install the trunk garnish onto the body, and fasten the tabs that attach the trunk garnish to the body.
NOTE: Make sure the trunk garnish is firmly attached to the body.

Courtesy of TESLA, INC.
Fasten the push clips (x2) that attach the ends of the trunk garnish to the body.
NOTE: LH shown, RH similar.

Courtesy of TESLA, INC.
Close the trunk.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.