Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTESLA2018MODEL 3 BASEREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMINTERIOR TRIM (MODEL 3)HEADLINERHEADLINER (NON-HEAT PUMP) - REMOVE AND REPLACEREMOVE

2018 Tesla Model 3 Base

Headliner (Non-Heat Pump) - Remove and Replace: Remove

2018 Tesla Model 3 BaseSECTION Remove

Remove the headliner. See Headliner (Non-Heat Pump) (Remove and Install) .
Release the clips that attach the LH and RH headliner tweeter covers to the headliner, and remove the tweeter covers from the headliner.

Courtesy of TESLA, INC.
Disconnect the electrical harness from the front overhead console connector.

Courtesy of TESLA, INC.
Release the clips that attach the front overhead console to the headliner, and then remove the console from the headliner.

Courtesy of TESLA, INC.
Disconnect the electrical harness from the rear overhead console connector.

Courtesy of TESLA, INC.
Release the clips that attach the rear overhead console to the headliner, and then remove the console from the headliner.

Courtesy of TESLA, INC.
Release the clips that attach the LH coat hook bezel to the LH coat hook assembly, and then remove the LH coat hook assembly from the headliner.

Courtesy of TESLA, INC.
Release the clips that attach the RH coat hook bezel to the RH coat hook assembly, and then remove the RH coat hook assembly from the headliner.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.