Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Sliding Lid - Center Console - Remove and Replace: Remove
2018 Tesla Model 3 BaseSECTION Remove
- Remove the center console. See CENTER CONSOLE (2ND GENERATION) (REMOVE AND REPLACE) .NOTE: Do not remove the security controller.
- Remove the cup holder. See CUP HOLDER (REMOVE AND REPLACE) .
- Disconnect the sliding lid connector and release the connector from the console assembly.
- Remove the screws (x9) that attach the sliding lid to the center console assembly.
Tip: Use of the following tool(s) is recommended:
- Torx T20 socket
- 4 in extension
- 1/4 in std ratchet
- Remove the sliding lid from the console assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.