Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Module - Inductive Charger - Center Console (2.0) - Remove and Replace: Remove
2018 Tesla Model 3 BaseSECTION Remove
- Open the front doors.
- Move the front seats fully rearward and into the lowest position.
- Pivot the center console armrest up.
- Release the clips (x17) that attach the center console decor trim to the assembly.
- Disconnect the center console inductive charger module electrical connector, and then release the surrounding clips that attach the center console decor to the center console to remove the assembly from the center console.
- Remove the screws that attach the center console wireless charger module to the center console decor.
Tip: Use of the following tool(s) is recommended:
- T20 socket
- 4 in extension
- Release the tabs that attach the center console wireless charger module to the center console decor, and then remove the module from the assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.