Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTESLA2018MODEL 3 BASEREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMINTERIOR TRIM (MODEL 3)CENTER CONSOLECENTER CONSOLE (2.0) - REMOVE AND REPLACEINSTALL
2018 Tesla Model 3 Base
Center Console (2.0) - Remove and Replace: Install
2018 Tesla Model 3 BaseSECTION Install
- Position the security controller removed from the original center console onto the new center console cup holder decor, and then install the screws (x2) that attach the security controller to the cup holder decor.
1.6 N.m (1.2 ft-lbs)
- Connect the security controller electrical connector, and then install the clips (x6) that attach the cup holder decor to the center console assembly.
- Position the bright work onto the center console assembly, and then secure the tabs (x12) that attach the bright work to the center console assembly.NOTE: Verify there are no gaps along the trim.
- Install the bolts (x14) that attach the bright work to the center console.
- Position the center console decor onto the center console assembly, connect the electrical connector, and then fasten the clips (x17) that attach the decor to the center console.
- With an assistant, install the center console into the vehicle as follows:
- Tilt the front of the center console downwards.
- Slide the center console towards the front of the vehicle.
- Tilt the rear of the center console downwards until it is in place.
- Connect the electrical connector that is located at the RH front of the center console.CAUTION: Ensure the connector is properly installed. Perform a push-pull test before continuing this procedure.
- Connect the electrical connector in the rear of the center console.CAUTION: Ensure the connector is properly installed. Perform a push-pull test before continuing this procedure.
- Install the bolts that attach the RH front of the center console to the body.
7 N.m (5.2 ft-lbs)
NOTE: Use of the following tool(s) is recommended:- 10 mm socket
- 4 in extension
- 1/4 in std ratchet
- 1/4 in torque wrench (installation only)
- Install the RH center console side panel carpet. See SIDE PANEL - CENTER CONSOLE - LH (REMOVE AND REPLACE) .
- Install the front passenger floormat.
- Reconnect 12V power. See 12V/LV POWER (DISCONNECT AND CONNECT) .
- Install the bolt that attaches the RH rear of the center console to the body. Repeat this step for the LH rear of the center console.
- Install the center console lower rear panel. See PANEL - LOWER REAR - CENTER CONSOLE (REMOVE AND REPLACE) .
- Repeat step 9 through step 11 for the LH side of the vehicle.
- Move the front seats to the original positions.
- Raise all the windows and close all the doors.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.