SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTESLA2018MODEL 3 BASEREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMINTERIOR TRIM (MODEL 3)CENTER CONSOLECENTER CONSOLE (2.0) - REMOVE AND INSTALLINSTALL
2018 Tesla Model 3 Base

Center Console (2.0) - Remove and Install: Install

2018 Tesla Model 3 BaseSECTION Install
  1. With an assistant, install the center console into the vehicle as follows:
    1. Tilt the front of the center console downwards.
    2. Slide the center console towards the front of the vehicle.
    3. Tilt the rear of the center console downwards until it is in place.
  2. Connect the electrical connector that is located at the RH front of the center console.
    CAUTION: Ensure the connector is properly installed. Perform a push-pull test before continuing this procedure.
    G00643631Courtesy of TESLA, INC.
  3. Connect the electrical connector in the rear of the center console.
    CAUTION: Ensure the connector is properly installed. Perform a push-pull test before continuing this procedure.
    G00643632Courtesy of TESLA, INC.
  4. Reconnect 12V power. See 12V/LV POWER - DISCONNECT AND CONNECT .
  5. Install the bolt that attaches the RH rear of the center console to the body.

    7 Nm (5.2 lbs-ft) 

    G00643633Courtesy of TESLA, INC.
  6. Install the bolt that attaches the LH rear of the center console to the body.

    7 Nm (5.2 lbs-ft) 

    G00643636Courtesy of TESLA, INC.
  7. Install the center console lower rear panel. See Panel - Lower Rear - Center Console - Remove and Replace .
  8. Install the bolts that attach the RH front of the center console to the body.

    7 Nm (5.2 lbs-ft) 

    NOTE: Use of the following tool(s) is recommended:
    • 10 mm socket
    • 4 in extension
    • in std ratchet
    • in torque wrench (installation only)
    G00643634Courtesy of TESLA, INC.
  9. Install the RH center console side panel carpet. See Side Panel - Center Console - LH - Remove and Replace 
  10. Install the front passenger floormat.
  11. Return the front passenger seat to its original position.
  12. Install the bolts that attach the LH front of the center console to the body.

    7 Nm (5.2 lbs-ft) 

    NOTE: Use of the following tool(s) is recommended:
    • 10 mm socket
    • 4 in extension
    • in std ratchet
    • in torque wrench (installation only)
    G00643635Courtesy of TESLA, INC.
  13. Install the LH center console side panel carpet. See Side Panel - Center Console - LH - Remove and Replace 
  14. Install the driver floormat.
  15. Return the driver seat to its original position.
  16. Raise all the windows and close all the doors.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.