Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Window Regulator - Recalibrate
Last Modified: 17/03/2023 06:00:16
- Get into the driver seat, and then close the door.
- Use the touchscreen to enable Service Mode. See SERVICE MODE
- Unlock the vehicle Gateway: press and hold the brake pedal, and then push and hold the turn signal stalk fully up for approximately 10 seconds.NOTE:
The MCU displays GTW UNLOCKING. Once the gateway is unlocked, the MCU will display GTW UNLOCKED as well as a countdown timer that indicates the remaining time in seconds for the gateway to be unlocked (max. 90 minutes).
- On the touchscreen, touch Controls > Service Mode > Closures > Windows > Calibrate Windows > Start. NOTE:
During window calibration, all windows will roll up and down until window calibration is complete.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.