Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Switch - Window - Driver - Remove and Replace: Install
2018 Tesla Model 3 BaseSECTION Install
- Remove the jumper harness from the new driver window switch.
- Position the driver window switch into the vehicle, connect the electrical connector, and then secure the clips (x4) that attach the switch to the door trim panel.
- Hook the front edge of the bolt cover to the door panel, move the puddle light harness into the door panel, and then pivot the bolt cover up.
- Install the bolt that attaches the lower bolt cover to the LH front door trim panel.
6 N.m (4.4 ft-lbs)
Tip: Use of the following tool(s) is recommended:
- T30 socket
- Raise the LH front window and close the LH front door.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.