Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Strut - Trunk - Remove and Replace: Remove
2018 Tesla Model 3 BaseSECTION Remove
- Remove the trunk garnish. See GARNISH - TRUNK (REMOVE AND REPLACE) .
- Near the LH side of the vehicle interior where the trunk garnish was removed, disconnect the electrical harness from the trunk power strut electrical connector.
- Push the trunk power strut rubber grommet through the body of the vehicle.
- Support the trunk with a prop.
- Release the clip that attaches the upper end of the trunk power strut to the trunk lid, and then separate the power strut from the trunk lid ball stud.
- Release the clip that attaches the lower end of the trunk power strut to the vehicle, and then remove the power strut from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.