Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Glass - Roof - Fixed - Remove and Replace: Remove
2018 Tesla Model 3 BaseSECTION Remove
- Open all the doors and lower all the windows.
- Apply masking tape to protect the paint on the vehicle.
- Measure and record the gaps from the fixed roof glass to windshield, body sides, and backlight glass.NOTE: The gap measurements are used for the installation of the fixed roof glass.
- Prepare the WRD Spider 3 glass removal kit.
Tip: Use of the following tool(s) is recommended:
- WRD Spider 3 - 1571168-00-A
- Secure the line to the starter tool and push the tool through the urethane at the LH rear corner of the fixed roof glass assembly.CAUTION: Be careful not to damage the headliner assembly and exterior paint.
- Release the line from the starter tool and wrap the line around the exterior of the fixed roof glass assembly.NOTE: Make sure enough length is pulled through the glass.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.