Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Glass - Backlight (Heat Pump) - Remove and Install: Remove
2018 Tesla Model 3 BaseSECTION Remove
- Open all doors and lower the windows.NOTE: Latch the rear doors to prevent accidental closure.
- Move the front seats fully forward.
- Release the clips that attach the LH upper B-pillar trim to the B-pillar, and then move the trim aside.
- Remove the LH side rail trim. See TRIM - SIDE RAIL - LH (REMOVE AND REPLACE) .
- Release the clip that attach the screw covers to the LH rear coat hook.
- Remove the screw that attach the LH rear coat hook to the body.
- Repeat step 3 through step 6 for the RH side of the vehicle.
- Release clips (x4) that attach the rear end of the headliner to the body.NOTE: If necessary, use an air bladder between the headliner and body for additional clearance.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.