Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTESLA2018MODEL 3 BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEEXTERIOR/INTERIOR TRIMBODY -- MODEL 3BODY PANELSHOOD - REMOVE AND INSTALLINSTALL
2018 Tesla Model 3 Base
Hood - Remove and Install: Install
2018 Tesla Model 3 BaseSECTION Install
Tip: For instructions on how to align the hood, refer to HOOD ALIGNMENT .
- With an assistant, install the hood assembly onto the vehicle and align the tape marks with the hood hinges.
- Loosely install the nuts that attach the hood assembly to the LH and RH hood hinges, but do not tighten the nuts at this time.
- Use a prop to attach the hood assembly in the open position.
- Install the clips that attach the LH and RH hood gas struts to the hood assembly.
- Perform gap and flush adjustments on the hood assembly, if necessary.
- Tighten the nuts that attach the hood assembly to the LH and RH hood hinges, and then remove the tape used to mark the hood hinge mounting locations.
15 N.m (11.1 ft-lbs)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.