Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Light - Side Repeater - Front - LH - Remove and Replace: Remove
2018 Tesla Model 3 BaseSECTION Remove
WARNING:
Whenever a camera has been moved out of its original position (for example, a camera or windshield replacement), camera calibration data must be cleared using the vehicle touchscreen: Controls > Service > Camera Calibration > Clear Calibration
.
- Open the LH front door and lower the LH front window.
- Enable Service Mode by using the touchscreen. See Service Mode .
- Apply protective tape to the LH front fender around the LH front side repeater light.
- Release the clips (x2) at the bottom of the LH front side repeater light that attach the light to the LH front fender, and then separate the light from the fender.CAUTION: If reinstalling the same side repeater, take care not to damage the mounting tabs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.