Module - Body Controller - LH (RHD) - Remove and Replace: Install

2018 Tesla Model 3 BaseSECTION Install
  1. Install the clip that attach the shroud to the LH body controller module.
    NOTE: Make sure that both clips are fully seated so that the edge of the shroud is parallel with the line on the back of the LH body controller module.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.