Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 LE, STANDARD TRANSREPAIR AND DIAGNOSISBODY & FRAMEGLASS/WINDOWS/MIRRORS (2)REPAIR INSTRUCTIONSREAR END DOOR WINDOW/BACK WINDOW DEFOGGER RELAY INSPECTION
2013 Suzuki SX4 LE, Standard Trans
Rear End Door Window/Back Window Defogger Relay Inspection
2013 Suzuki SX4 LE, Standard TransSECTION Rear End Door Window/Back Window Defogger Relay Inspection
- Disconnect negative (-) cable from battery.
- Remove junction block assembly for inspection of rear end door window/back window defogger relay. For removal, refer to BCM REMOVAL AND INSTALLATION (Hatchback).
- Remove rear end door window defogger relay (1) (Hatchback) or back window defogger relay (4) (Sedan) from junction block assembly (2).
- Check that there is no continuity between terminal "c" and "d". If there is continuity, replace relay.
- Check that there is continuity between terminals "c" and "d" when a 12 V battery is connected to terminals "a" and "b".
If malfunction is found, replace it with a new one.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.