Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISTRANSMISSIONTRANSFER CASETRANSFER ASSEMBLYSPECIAL TOOLS AND EQUIPMENTSPECIAL TOOL
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Special Tool
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Special Tool
SPECIAL TOOL REFERENCE CHART
| 09900-20607 Dial gauge |
09900-20701 Magnetic stand |
||
| 09912-34510 Case separator |
09913-50121 Oil seal remover |
||
| 09913-75520 Bearing installer |
09913-76010 Bearing installer |
||
| 09913-84510 Bearing installer |
09913-85210 Bearing installer |
||
| 09913-85230 Bearing remover tool |
09922-76140 Bevel pinion shaft |
||
| 09922-76150 Bevel pinion nut |
09922-76340 Bevel pinion rear collar |
||
| 09922-76420 Bevel pinion front collar |
09922-76430 Bevel pinion front collar |
||
| 09924-07710 Synchronizer hub installer |
09924-74510 Bearing and oil seal handle |
||
| 09924-84510-005 Bearing installer attachment (D) |
09925-15410 Oil seal installer |
||
| 09925-16010 Drive gear bearing installer |
09925-16310 Bearing installer |
||
| 09925-18011 Transmission gear, bush and bearing installer |
09925-98221 Bearing installer |
||
| 09930-40113 Flywheel rotor holder |
09940-54910 Front fork oil seal install driver |
||
| 09944-88210 Bearing housing installer |
09944-96011 Bearing outer race remover |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.