Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISTRANSMISSIONTRANSFER CASETRANSFER ASSEMBLYREPAIR INSTRUCTIONSREDUCTION DRIVEN GEAR ASSEMBLY DISASSEMBLY AND REASSEMBLYREASSEMBLY

2013 Suzuki SX4 Crossover, Automatic CVT Trans

Reduction Driven Gear Assembly Disassembly and Reassembly: Reassembly

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Reassembly

CAUTION:

Using bolts other than the specified bolts may cause problems with the rear differential. Use only the specified bolts.

Install right bearing (1) to reduction driven gear (2) using special tools and hydraulic press.
Special Tool
1. 09924-74510
2. 09925-16310
  
  Fig 1: Installing Right Bearing To Reduction Driven Gear Using Special Tools
  Courtesy of SUZUKI OF AMERICA CORP.
Install bevel gear (1) to reduction driven gear (2) using special tools and hydraulic press.
Special Tool
1. 09924-07710
2. 09924-84510-005
3. 09925-15410
  
  Fig 2: Installing Bevel Gear To Reduction Driven Gear Using Special Tools
  Courtesy of SUZUKI OF AMERICA CORP.
Install left bearing (1) to reduction driven gear (2) using special tools and hydraulic press.
Special Tool
1. 09913-84510
2. 09924-84510-005
  
  Fig 3: Installing Left Bearing To Reduction Driven Gear Using Special Tools
  Courtesy of SUZUKI OF AMERICA CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.