Enabled conditions

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Enabled conditions
SECONDARY PRESSURE CONTROL SOLENOID VALVE RATIONALITY MONITOR ENABLED CONDITIONS CHART

Parameter Minimum Maximum
P0776:Β 
Shift position "D" range
Vehicle speed 10 km/h (6 mile/h) -
Accelerator pedal position 12.5% -
Engine speed 450 RPM -
Line pressure control solenoid valve No DTC (P0962, P0963)
Stepper motor No DTC (P1816)
Transmission range sensor No DTC (P0707, P0705)
Secondary pressure control solenoid valve No DTC (P0966, P0967)
Primary pulley speed sensor No DTC (P0717, P0716)
Secondary pulley speed sensor No DTC (P0722, P0721)
Primary pressure sensor No DTC (P0842, P0843)
Secondary pressure sensor No DTC (P0847, P0848)
TCC solenoid valve No DTC (P2764, P2763)
Lock-up/select switching solenoid valve No DTC (P1810)
CAN communication No DTC (U0100, U0073)
Battery voltage 10.5 V -
P0777:Β 
Shift position Other than "N" range
Brake light switch OFF
Transmission fluid temperature -20 Β°C (-4 Β°F) -
Change rate of vehicle speed - +/- 15 km/h/10 ms
Change rate of accelerator pedal position - +/- 6.25%/10 ms
CAN communication No DTC (U0100, U0073)
Line pressure control solenoid valve No DTC (P0962)
Secondary pressure control solenoid valve No DTC (P0966)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.