Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSCONTINUOUSLY VARIABLE TRANSAXLE (CVT)GENERAL DESCRIPTIONOBD SYSTEM DESCRIPTION - COMPREHENSIVE COMPONENT CIRCUIT MONITORMONITORING PROCEDURE
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Monitoring Procedure
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Monitoring Procedure
Input signal of the following are checked for open, short of circuit by monitoring input voltage.
- Primary and secondary pressure sensor power supply circuit (P0641)
- Transmission range sensor (P0707)
- CVT fluid temperature sensor (P0712, P0713)
- Primary pulley pressure sensor (P0842, P0843)
- Secondary pressure sensor (P0847, P0848)
- Line pressure control solenoid valve (P0962, P0963)
- Secondary pressure control solenoid valve (P0966, P0967)
- Sensor ground circuit (P1970)
- TCC solenoid valve (P2763, P2764)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.