SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSCONTINUOUSLY VARIABLE TRANSAXLE (CVT)DIAGNOSTIC INFORMATION AND PROCEDURESDTC P0826: MANUAL MODE CONTROL CIRCUITDTC DETECTING CONDITION AND TROUBLE AREA
2013 Suzuki SX4 Crossover, Automatic CVT Trans

DTC Detecting Condition and Trouble Area

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION DTC Detecting Condition and Trouble Area
P0826 SYMPTOM DIAGNOSIS DESCRIPTION CHART

DTC detecting condition Trouble area
DTC P0826: Manual mode Control Circuit 
This DTC is detected if any one of the following conditions is fulfilled.
  • Manual mode switch ON signal continues to be input for more than 5 sec. even after "P", "R" or "N" range signal input.
  • ON signal of shift-down switch or shift-up switch is input for more than 5 sec. even while manual mode switch is OFF.

(1 D/C detection logic)
  • Manual mode shift switch (include manual mode switch, shift-up switch and shift-down switch) and/or its circuit
  • TCM
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.