SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 2 (MANUAL TRANSMISSION/TRANSAXLE)REPAIR INSTRUCTIONSMANUAL TRANSAXLE ASSEMBLY DISASSEMBLY AND REASSEMBLYDISASSEMBLY
2013 Suzuki SX4 Crossover, Automatic CVT Trans

Manual Transaxle Assembly Disassembly and Reassembly: Disassembly

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Disassembly
WARNING: This page is about a different variant/trim than selected.
  1. Remove back up lamp switch. See BACK UP LAMP SWITCH REMOVAL AND INSTALLATION .
  2. Remove transaxle case bolts.
  3. Remove transaxle left side case (1) from right case using special tool.

    Special Tool 

    1. 09912-34510 
      Fig 1: Identifying Transaxle Left Side Case
      G06868618Courtesy of SUZUKI OF AMERICA CORP.
  4. Remove reverse gear shift lever bolts (1) and reverse gear shift lever (2).
    Fig 2: Identifying Reverse Gear Shift Lever Bolts
    G06868619Courtesy of SUZUKI OF AMERICA CORP.
  5. Tapping input shaft end with plastic hammer, push it out as assembly from case a little, then take out input shaft assembly (1), countershaft assembly (2), high speed gear shift shaft (3), low speed gear shift shaft (4), 5th and 6th gear shift shaft (5), reverse gear shift (6) and reverse gears (7).
    Fig 3: Identifying Manual Transaxle Assembly Components
    G06868620Courtesy of SUZUKI OF AMERICA CORP.
  6. Remove differential assembly from right case.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.