Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 2 (MANUAL TRANSMISSION/TRANSAXLE)REPAIR INSTRUCTIONSBACK UP LAMP SWITCH REMOVAL AND INSTALLATIONINSTALLATION
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Back Up Lamp Switch Removal and Installation: Installation
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Installation
WARNING: This page is about a different variant/trim than selected.
Reference: BACK UP LAMP SWITCH INSPECTION
- Apply oil to new O-ring (1) and tighten back up lamp switch (2) to specified torque.
Tightening torque
Back up lamp switch (a): 19 N.m (1.9 kg-m, 14.0 lbf-ft)
- Connect back up lamp switch connector.
- Install air cleaner assembly. See AIR CLEANER ASSEMBLY REMOVAL AND INSTALLATION .
- Install battery and tray with ECM. See ENGINE CONTROL MODULE (ECM) REMOVAL AND INSTALLATION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.