SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (CLUTCH SYSTEM)SPECIFICATIONSTIGHTENING TORQUE SPECIFICATIONS
2013 Suzuki SX4 Crossover, Automatic CVT Trans

Tightening Torque Specifications

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Tightening Torque Specifications
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS

Fastening part Tightening torque
N.m kgf-m lbf-ft
Clutch bleeder plug 5 0.5 4.0
CPP switch lock nut 7.5 0.75 5.5
Clutch master cylinder nut 13 1.3 9.5
Clutch operating cylinder assembly mounting bolt 10 1.0 7.5
Clutch fluid pipe flare nut 16 1.6 11.5
Clutch cover bolt 23 2.3 17.0
NOTE: The specified tightening torque is described in the following.
CLUTCH COVER AND CLUTCH DISC COMPONENTS 

Reference: 

For the tightening torque of fastener not specified in this Service Information, refer to FASTENERS INFORMATION .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.