Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 98 (DIFFERENTIAL ASSEMBLY)DIAGNOSTIC INFORMATION AND PROCEDURES4WD POSITION INDICATOR OPERATION CHECK
2013 Suzuki SX4 Crossover, Automatic CVT Trans
4WD Position Indicator Operation Check
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION 4WD Position Indicator Operation Check
WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition switch to OFF position.
- Check that 4WD position indicators turn on for about 2 seconds and then turns off.
If any faulty condition is found, proceed to 4WD POSITION INDICATOR DOES NOT COME ON AT IGNITION SWITCH ON BUT ENGINE STOPS or 4WD POSITION INDICATOR REMAINS ON STEADY AT IGNITION SWITCH ON .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.