Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 95 (MANUAL TRANSMISSION)REPAIR INSTRUCTIONSBACK UP LAMP SWITCH REMOVAL AND INSTALLATIONINSTALLATION
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Back Up Lamp Switch Removal and Installation: Installation
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Installation
WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
Reference: BACK UP LAMP SWITCH INSPECTION
- Apply oil to new O-ring (1) and tighten back up lamp switch (2) to specified torque.
Tightening torque
Back up lamp switch (a): 19 N.m (1.9 kg-m, 14.0 lbf-ft)
- Connect back up lamp switch connector.
- Install air cleaner assembly see AIR CLEANER ASSEMBLY REMOVAL AND INSTALLATION .
- Install battery and tray with ECM see ENGINE CONTROL MODULE (ECM) REMOVAL AND INSTALLATION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.