Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 80 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSHEADLIGHT HOUSING REMOVAL AND INSTALLATIONINSTALLATION
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Headlight Housing Removal and Installation: Installation
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Installation
WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
Reverse removal procedure noting the following.
- Install headlight mounting bolts and clip (1), and then tighten headlight mounting bolts ("1" - "2") according to numerical order as shown in figure.
- After installation, be sure to inspect and adjust aiming referring to HEADLIGHT AIMING ADJUSTMENT WITH SCREEN .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.