Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 76 (AIR CONDITIONING SYSTEM - MANUAL A/C)REPAIR INSTRUCTIONSOPERATION PROCEDURE FOR REFRIGERANT CHARGENOTES
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Operation Procedure for Refrigerant Charge: Notes
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Notes
WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Contact of liquid HFC-134a (R-134a) refrigerant with skin and eyes will cause frostbite. The refrigerant cools the surface coming in contact with it to a temperature much lower than the freezing point of water. Avoid contact with HFC-134a (R-134a) refrigerant and wear goggles and gloves whenever handling the refrigerant. Should the refrigerant happen to contact your eyes or skin, immediately take action as described below to prevent aggravating the condition:
- In the event of eye contact, do not rub the eye you're your hand. Instead, pour fresh cold water over the eye to gradually raise the temperature. After washing the eye thoroughly with water, receive medical attention as soon as possible.
- If liquid HFC-134a (R-134a) contacts your skin, wash the affected area thoroughly with water. Since the skin may have been frostbitten, receive medical attention.
- If HFC-134a (R-134a) is exposed to high temperatures, it turns into a poisonous gas. Be sure to take the following precautions to prevent health problems caused by HFC-134a (R-134a) gas.
- Do not handle refrigerant in or near any area where welding or steam cleaning is performed.
- Keep refrigerant in a cold and dark place. Avoid storing it under direct sunlight, in a place close to fire or inside a vehicle.
- If HFC-134a (R-134a) is burned, avoid breathing fumes.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.