SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 70 (BODY ELECTRICAL CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC CLEARANCEWITHOUT USING SUZUKI SCAN TOOL
2013 Suzuki SX4 Crossover, Automatic CVT Trans

Without Using SUZUKI Scan Tool

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Without Using SUZUKI Scan Tool
WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch to OFF position.
  2. Perform following Steps  a) to  d) within 10 seconds after ignition switch is turned ON and engine stops.
    1. Turn headlight switch to "SMALL" position.
    2. Turn headlight switch to "OFF" position.
    3. Repeat Steps  a) and  b) 3 times.
    4. Press and release driver side door switch 4 times.
  3. After completing above Steps, confirm that no malfunction DTC is detected.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.