SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 7 (AIR BAG SYSTEM)SCHEMATIC AND ROUTING DIAGRAMSIR SCHEMATIC ICONS
2013 Suzuki SX4 Crossover, Automatic CVT Trans

SIR Schematic Icons

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION SIR Schematic Icons
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
ICON DEFINITION

Icon Icon Definition
G04844086Courtesy of SUZUKI OF AMERICA CORP.
WARNING: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR DISABLING AND ENABLING . Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs.
G04844087Courtesy of SUZUKI OF AMERICA CORP.
NOTE:
  • In order to prevent accidental deployment, the shorting bars close in order to short the connectors when the connectors are separated.
  • Twisted-pair wires provide an effective shield that helps protect sensitive electronic components from electrical interference. If the wires were covered with shielding, install new shielding.

    In order to prevent electrical interference from degrading the performance of the connected components, you must maintain the proper specification when making any repairs to the twisted-pair wires shown:

    • The wires must be twisted a minimum of 9 turns per 31 cm (12 in) as measured anywhere along the length of the wires
    • The outside diameter of the twisted wires must not exceed 6.0 mm (0.25 in)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.