Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 59 (ENGINE ELECTRICAL DEVICES)REPAIR INSTRUCTIONSVIN REGISTRATION (EVAP LEAK CHECK MODEL)
2013 Suzuki SX4 Crossover, Automatic CVT Trans
VIN Registration (EVAP Leak Check Model)
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION VIN Registration (EVAP Leak Check Model)
WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
- Connect SUZUKI scan tool to data link connector (DLC) (1) located on under side of instrument panel at driver's seat side
Special Tool
(A): SUZUKI scan tool (SUZUKI-SDT)
- Check the VIN shown on the left side of instrument panel.
- Turn ignition switch to ON position.
- Select "VIN registration" under "Utility" menu of SUZUKI scan tool.
- Register VIN according to the instructions indicated on the SUZUKI scan tool.NOTE: For details, refer to the operators manual for SUZUKI scan tool.
- Before completed the VIN registration, check that VIN data indicated on the SUZUKI scan tool is correct.
If not, re-register VIN data into ECM correctly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.