Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 59 (ENGINE ELECTRICAL DEVICES)REPAIR INSTRUCTIONSENGINE COOLANT TEMPERATURE (ECT) SENSOR REMOVAL AND INSTALLATIONINSTALLATION
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Engine Coolant Temperature (ECT) Sensor Removal and Installation: Installation
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Installation
WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
Reference: ENGINE COOLANT TEMPERATURE (ECT) SENSOR INSPECTION
Reverse removal procedure noting the following.
- Clean mating surfaces of ECT sensor and water outlet cap.
- Check O-ring for damage and replace, if necessary.
- Tighten ECT sensor (1) to specified torque.
Tightening torque
ECT sensor (a): 12.5 N.m (1.25 kg-m, 9.0 lbf-ft)
- Connect connector to ECT sensor securely.
- Refill coolant. See COOLING SYSTEM REFILLING .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.